13
amplifier is always on whenever the Power Switch (1) is in the On position. When set
to Auto, the amplifier will power on when an audio signal is detected and will
power off after a few minutes without an audio signal on the input. When set to the
Trigger position, the amplifier turns on and off when a 12-volt signal is detected on
the Trigger In (8). When using the Auto or Trigger options, the Power Switch (1) on
the front panel must be set to the On position.
12.
Using a 1/8" flat head screwdriver, turn the Volume (5) control fully
counterclockwise to the minimum position.
13.
Ensure that the Power Switch (1) is in the Off position.
14.
Plug the C13 connector on the included AC power cord into the C14 Power In (10)
connector, then plug the other end into a nearby AC power outlet.
15.
(Optional) Squeeze both sides of the included power cord anchor, insert the two
ends into the two loops above the Power In (10) connector, then release the anchor
so the two ends lock into the two loops. Position the anchor over the boot of the
power cord connector, so that it cannot accidentally disconnect from the amplifier.
16.
Flip the Power Switch (1) to the On position.
17.
Plug in and power on your audio source device, then start audio playback.
18.
Set the volume control on your preamplifier, television, or other audio source
device to the maximum position.
19.
Using a 1/8" flat head screwdriver, slowly turn the Volume (5) control clockwise until
the volume level is at the loudest you would ever want it to be.