Monogram ZJ7000, Installation Instructions Manual

Page: 11 / 32

31-10700-6
11
STEP 4 SECURE CUSTOM PANEL
TO METAL MOUNTING
PANEL
■ Lay the custom panel, appearance side down, on a
clean surface.
■ Remove all tape and packing material from the metal
panel.
■ Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
■ Align the lamp hole in the panel with the mounting
panel.
■ Confirm squareness and correct position of the metal
panel to the custom panel.
STEP 7
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
■ A custom handle (not supplied) may be installed.
■ Drill pilot holes through the front of the custom panel
and through the metal panel to match the chosen
handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
STEP 8 I
NSTALL ASSEMBLED PANEL
TO THE DRAWER
■ Determine which holes in the metal panel line up with
the holes in the exposed drawer front and marked the
screw hole locations onto the custom panel.
■ Drill 1/8” deep holes into the custom panel for
clearance to the #6 screws. The #6 screws will
extend into the custom panel slightly.
■ Using the #6 screws supplied in the bag, install the
custom panel assembly to the exposed drawer front
with seven screws.
■ The original #8 screws are not needed.
STEP 6
INSTALL LAMP JEWEL
■ Turn the assembly appearance side up.
■ Use plastic to wood adhesive to secure the lamp
jewel to the front of the wood panel. On the side with
the bulge, (see illustration) apply a small bead of
adhesive around the outside edge. Place the jewel
into the drilled hole.
STEP 5 FOR PANELS LESS THAN
3/4” THICK
■ Separate the custom panel and metal panel.
■ Apply a few horizontal beads of adhesive to the metal
panel. Avoid adhesive within 1” of lamp hole area and
outer edges.
STEP 5A
FOR PANELS MORE THAN
3/4” THICK
■ Separate the custom panel and metal panel.
■ Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and
drill pilot holes. Drill pilot holes sized to match screws
being used (screws not provided).
NOTE:
Select screw length carefully to avoid
penetration of the finished side.
Installation
Insert
Jewel
Appearance
Side
This Side
Against
Wood
Custom Handle
or Original Handle
NOTE: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.