Monogram ZIF360NHLH, Installation Instructions Manual

Page: 35 / 52

STEP 7 ADJUST DOOR SWING
NOTE: This appliance has a 3-position door stop. When
space does not allow the door to swing open fully to
115°, you may change the door swing to a 90° opening.
Skip this step if door opening is satisfactory for your
installation situation.
• Open the grille to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. Use Pliers to unscrew the door stop and
reinstall in the 90 degree position. Close the grill.
Installation Instructions - Flush Installation
35
Pin Location
for 90°
Door Swing
Pin Location
as Shipped
for 115°
Door Swing
STEP 8 INSTALL GRILLE PANEL
• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especiall
y
with children. To minimize this risk y ou must
follow the installation instructions for cabinet
dimensions, trim assembl
y , and door stop angle.
Door Trim Pinch Point Hazard
WARNING