33
Installation Instructions - Flush Installation
STEP 7 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
Remove
Wire Cover
Trim Screws
• Reinstall the wire cover trim.
Pin Location
for 90°
Door Swing
Pin Location
as Shipped
for 115°
Door Swing
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
STEP 8 INSTALL GRILLE PANEL
• Raise the grille panel to stop position.
• Loose screws on side trim behind frame. Remove
bottom trim.
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especially
with children. To minimize this risk you must
follow the installation instructions for cabinet
dimensions, trim assembly, and door stop angle.
Door Trim Pinch Point Hazard
WARNING