27
Design Guide - Flush Installation
SIDE PANELS
Side panels must be used
whenever the sides of
the refrigerator will be
exposed. The 1/4
”
side
panels will slip into the
side case trim. Secure the
panels to the refrigerator
with stick-on hook and
loop fastener strips. Order
the side panels from the
cabinet manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on installation height.
ZUG2 GRILLE PANEL DIMENSIONS
The ZUG2 unified grille panel kit provides for the
installation of a framed or overlay grille panel.
Assemble the
overlay panels
in the same
manner as
the door and
drawer panels.
Framed Panel Dimensions
A (Width)
B (Height)
3/4
”
Routed Framed Panel
74
”
10-11/16
”
Overlay Panel Dimensions
A (Width)
B (Height)
1/4
”
Backer Panel
69-7/8
”
8-7/8
”
0.10
”
Spacer Panel
68-1/2
”
7-5/8
”
1/2
”
Flat Overlay Panel
74
”
10-11/16
”
ZUG2 Unified Grille Panel Kit
• If you are installing two units, side by side, the
installation space must be 75” wide.
Note: Additional cutout width may be required when
side panels are used. Add side panel thickness to the
finished cutout to calculate rough-in width.
• The water and electrical locations for each product
must be located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply is
recommended for each product.
Note: When implementing a dual installation, the
factory installed standard case trim should be used on
the handle side of each unit and the supplied flush case
trim should be used on the hinge side of each unit.
75" Finished Width
4-5/16"
24-3/16"
9"
7"
7-1/2" 7-1/2"
7"
5-1/2"
9"
5-1/2"
Electrical
Electrical
Area
Cold Water
Supply
Wall View
Cold Water
Supply
24" Minimum
Cutout Depth
85" Max
Finished
Opening
75-1/2" From
Floor to Bottom
of Electrical Area
3-1/2"
3-1/2"
3-1/2"
3-1/2"
3-1/2"
3-1/2" 3-1/2"
3-1/2"
3-1/2"
3-1/2"
INSTALLATION
*84"
2-9/16"
24"
*3" to 4"
3/16"
1-7/8"
SIDE CLEATS
Wood cleats are required to be installed vertically
down both sides of the cabinet opening to provide
depth stop for the refrigerator when installed into the
opening.
The cleat should be installed per the diagrams below
based on the type of panel being used.
5-1/4”
Finished
Cleat
Case Trim
1/2”
3/4” Panel
DOOR
TOP VIEW
5-3/8”
Finished
Cleat
Case Trim
1/2”
1/2” Panel
DOOR
TOP VIEW
Door panel dimensions for dual installation are:
FF Door: 46-9/16” x 36-7/8”
FZ Drawer: 22-7/16” x 36-7/8”
UNIFIED DOOR PANEL DIMENSIONS