CONTROL, CLOCK
Clock
To Set the Clock
The clock must be set for the
Press the
❑
2. Press the
automatic oven timing functions to
CLOCK
CLOCK pad.
A
INCREASE or
work properly. The time of day
DECREASE pad to
cannot be changed during a Timed
set the time of day.
Bake or CLEAN cycle.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer is a minute timer; it does
1. Press the
not control oven operations. The
TIMER
TIMER
maximum setting on the timer is
ON/OFF
ON/OFF pad.
9 hours and 55 minutes.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
“HR’’will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
To Reset the Timer
To Cancel the Timer
If “TIMER” is showing, press the INCREASE
Press the TIMER ON/OFF pad while the word
or DECREASE pad until desired time is reached.
“TIMER” is displayed.
If “TIMER” is not showing, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tones
The End of Cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the
pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the
pad for 10 seconds.
Power
After a power outage, when power is restored,
the display will flash and time shown will no longer
be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again.