Robin L sealer RevA19 17-01-19
CHANGING SEALING WIRES.
1. To remove the old wire, loosen earth screw 1, located in the right-hand front corner of the
seal arm, loosen the nut 2 at the spring loaded end and remove the two broken pieces.
2. Locate the new wire around the wire holder screw, between the nuts
and tighten the end nut.
3. Next, locate the other end of the wire around the earth screw 1, pulling to tension the
spring at the other end and tighten earth screw 1.
4. Take care that the 'Tail' of the new wire at either end does not touch any metal part (other
than the screw to which it is fastened) either when the seal arm is 'UP' or 'Closed', otherwise
an electrical short will result.
5. Repeat procedure for the side wire replacement.
ALWAYS ensure that the front to back (side) wire lies over the front wire (looking up from
below) at the crossover point.
1
2
WIRE
TENSION SPRING
