8
Preventive Maintenance:
The
Wireless
EZ
Communication Interface is virtually
maintenance free. In typical applications, once the appa-
ratus is properly setup, it will operate without any further
attention. The electronics are housed in a weatherproof
enclosure. In addition the PCBs are conformal coated
with a silicone-based material to further prevent electrical
influence by condensation. The electronics should peri-
odically be observed for any signs of contamination
caused by improper enclosure protection (i.e. insure cover
is fully engaged, and that wire entries are properly
sealed.)
Cleaning Requirements:
In the event that the antenna is fouled by external contam-
ination, reliable communication of the RF wireless signal
may be degraded. In these cases, clean antenna with a
soft damp towel.
MAINTENANCE
Fuse Replacement:
The fuse incorporated into the
Wireless
EZ
Communication Interface PCB is not intended for operator
replacement. A qualified technician can replace the appli-
cable fuse according to the following specifications.
If necessary, consult the factory for additional technical
assistance or for return of the
Wireless
EZ
Communication
Interface.
F1: Fuse, TR5-FAST, 315mA, 250V, SLO
Monitor Part #: 4722-0014
Figure 11
Summary of Contents for WirelessEZ
Page 6: ...6 Figure 9...
