11
Hardware Specifications
CN4
External card reader connector with the following pin-outs:
Pin
Function (Clock and Data)
Function (Weigand)
1
GND
GND
2
+5v
+5v
3
Card Detect
Data0
4
Clock
Data1
5
Data
N/C
CN11
The jumper on CN11 connects pin 4 of the AUX port to either 5v or Vin. By default there is no
jumper on this selector, therefore no voltage appears on pin 4 of the AUX port.
JB1
Jumper Block 1 has six individual jumpers labelled A through F. These jumpers determine various
states for the inputs from the DB15 connector.
By default none of the jumpers are set.
WARNING:
Never set jumpers
A
and
B
on at the same time. Doing so will short un-regulated
voltage (Vin) on to the 5v power rail for the board. This will almost immediately destroy the main
board’s chipset.
Summary of Contents for MB206
Page 1: ...MB206 Terminal Reference Guide From Version 6 58 02 www monitorbm com ...
Page 70: ...Version 6 Terminal Menu System Options 64 3 The terminal then resolves it to an IP address ...
Page 73: ...67 Terminal Interface Cables B W Copier Type 2 ACT812 Retail Handset ...
Page 74: ...Terminal Interface Cables 68 TMSR Barcode Mag Card Reader ...