GENERAL INSTALLATION
** Please follow the instructions below carefully to ensure proper
function of the device.
1. Insert the fiber optic probe into the handpiece and make sure it is
securely installed at the fixed position.
2. Connect the electric wire to the charger stand and plug it into an
electricity outlet.
**
NOTE:
Check to make sure the red
(CHARGE)
led light on the
left side is lit and immediately switch to
green
(READY)
led is lit.
3. Place the handpiece in the charger stand
to begin the initial charging as the
red
CHARGE)
led is lit.
4. Put on the anti-glare cone and the
protective shield.
5. Adjust the cone and shield position
according to the dentist's preference.
6. When the handpiece is fully charged, the
green
(READY)
led light will switch on.
(
IMPORTANT :
> Please make sure to fully charge the battery for at least 6 hours
before the FIRST time of using this device. This will insure the
full length of battery life.
> When battery power decreases to the lowest supply level, a
continuous beeping sound will ring for one minute to remind
the user to recharge.
OPERATION
MODES:
There are 3 modes at your
choice.
The working time of
M1
and
M3
can be reset while
the timer for
M2
is fixed.
M2 : Bleaching Mode
70% of full power.
Default time pre-set 15
minutes.
M3 : Pulse Mode
Full power 1 second on,
1 second off.
Default time 20 sec. with
optional time setting to the
user’s preference. (maximum
timer setting up to 90 sec. for
some particular application.)
M1 : Full Power
Default time is 8 sec. with optional
time setting to the user’s preference.
(maximum timer setting up to 90 sec.
for extra oral indirect application.)
Warning: Li-Ion Battery.
To prevent a possibility of the battery from locking out, leaking, heat
generation or explosion, please observe the following precautions:
Do not disassemb le.
Ke ep the battery dry
Ke ep away from high temp erature.
Do not crush.
Please charge the battery every 2-mo nths period if left idled.
Please recycle the battery.
Do not dispose the battery in fire to prevent injury or burns.
Do not short circuit.
Improper care-taking of the battery may result possible battery
burnt, it is recommended for regular battery check up by your
nearest local dealer to ensure proper functioning of the unit.
Charging
Stand by
Thermometer:
The thermometer symbol will blink after continuous usage of
about 30 consecutive sessions with each session lasts for 30
seconds. This function will shut off the unit to prevent the device
from over-heating.
Battery Level Indicator
Timer
E
N
G
L
IS
H
4
5
