Mongoose M60AM, Operation Manuals

Page: 5 / 25

ARMING
NORMAL OPERATION

Turn the engine off, close all windows and remove the keys from the ignition

Exit the vehicle and close all the doors (& bonnet & boot).

Press button one on the remote control.
The indicators flash once and the siren will chirp once to indicate that the system is armed.
The dash board warning light, LED, will slow flash to indicate the system is armed.

If your vehicle has central locking and it has been connected to this security system, the
doors will lock at the same time as arming.
NOTE: If the engine is automatically immobilised (occurs 30 seconds after ignition OFF) before you
had a chance to arm the system, press button one twice – once to turn off just the immobiliser and
the second time to fully arm and immobilise the system. The system can be programmed to arm
automatically 30 seconds after the last door is closed. See page 12.
OPEN CIRCUIT BYPASS
If any door, the bonnet or boot is left open upon arming, the siren will chirp once to signify the
system is armed and then sound briefly to inform you a circuit is still open. If ignored, that circuit will
not be protected. The open circuit (a door, the bonnet or boot) will automatically arm itself upon
closure.
CENTRAL LOCKING
- additional parts, at extra cost, may be required depending on vehicle equipment level.
This security system has built-in relays to operate a vehicles’ existing central locking system by remote
control. When connected, the doors will lock or unlock at the same time as arming or disarming.
SENSOR DISABLE
To turn off any sensors fitted, but arm the bonnet, boot and doors and immobilise the engine,
press button one followed by button two. See page 8 for full description.
5