33
VFC Vent Free Fireplace System
Monessen • VFC 24/32 Owner Manual • 20308011 • Rev A • 06/16
OPTIONAL ACCESSORIES
FORCED AIR KIT
If you are installing the forced air kit (Models BLO24T or
BLOT), see the installation instructions provided with the
kit for electrical wiring requirements or the blower instal-
lation section.
Model VFC24 uses blower model BLO24T.
Model VFC32 uses blower model BLOT.
The firebox must be connected to main power supply at
time of firebox installation. The blower must be installed
prior to the installation of the unvented heater. The electri-
cal connections must be made before the firebox is framed
and enclosed in the finished walls.
INSTALLING OPTIONAL FIREBRICK
PANELS
NOTE:
Firebrick liner kits may be used only with the VFC
vent free fireplace systems. Please verify the size and
model number of your insert to be certain the kit you pur-
chased is correct.
KIT CONTENTS:
• One (1) Center panel
• Two (2) self-drilling #8 screws
• One (1) Left panel
• Two (2) Brick retainer brackets
• One (1) Right panel
TOOLS REQUIRED:
Drill with 1/4" hex head or Phillips bit
INSTRUCTIONS:
1. Remove screen frame, stones, fireglass or logs (if ap-
plicable) per the VFC Installation and Operating In-
structions.
2. Place rear ceramic firebrick panel against the center of
the rear wall of the firebox. Place on rear log support
bracket.
3. Place left and right ceramic firebrick panels against
firebox sides and attach at the top with retainer bracket
with supplied self drilling screws.
4. Replace fireglass, stones and/or logs as applicable
and re-install screen frame.
Figure 37.
Install Side Firebrick
Panel
KT1434
install firebrick
Retainer
Brackets
KT1435
installed
Figure 38.
Install Back Firebrick
Panel
Summary of Contents for VFC24
Page 45: ......
