26
VFC Vent Free Fireplace System
Monessen • VFC 24/32 Owner Manual • 20308011 • Rev A • 06/16
LOG AND MEDIA PLACEMENT
5. Place the left middle log #5 with the
C
channel locking
the front and middle log in place.
Figure 28
6. Place the left rear log #6 by aligning the rear support
bracket to the cut out on the rear of log #6. The left side
will also align with the channel cut into log #5.
Figure
29
7. Place the top center log #7 by aligning the notch from
log #3 to the bottom. The front edge of the log #7 will
rest on the front grate horizontal bar.
Figure 30
Log placement complete.
GLASS ONLY PLACEMENT
NOTE:
Two (2) bags of glass are supplied with the fireplace.
Both bags may be used to cover the entire floor and burner.
We advise against using additional glass as too much can
cut off the proper amount of air the burner needs to operate
cleanly. This may cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. Be sure to use a single layer only over the
ported area so as not to impinge the flame.
2. Turn burner on and adjust glass over ported areas to
achieve an even, clean flame.
Figure 28.
Figure 29.
Figure 30.
Figure 31.
Summary of Contents for VFC24
Page 45: ......
