Using the 4 tapping screws (16) and supplied screwdriver (10) align the control panel with the pre-drilled holes and attach the control panel to the desk.
Reconnect the control panel to the motor.
STEP 10.
STEP 9.
Flip the base onto the frame so the feet are in the air. Check the motor is on the same side as the the 4 pre-drilled holes and lift the base onto the desk top.
Align the holes in the frame with the holes in the desk top and use the Allen key and 8 M6 screws (14) to fasten the base to the desk top.
STEP 11.
Carefully lift the desk onto its feet and plug the power cord into a power source. Ensure the cable port (17) is pushed into the cutout hole.
Note: Cable management (18) can be attached to the bottom of the desk.
Assembly Instructions
SIT STAND DESK
Same side
(14)
Motor
(13)
(12)
(11)
(16)
MONDO LYPTA SIT STAND DESK
