Monarch Zener Owner’s Manual v2. © Scooters Australia 2017.
10
To drive forward use either of the following:
•
Use your right hand fingers to pull back on the right side of the throttle control lever.
•
Use your left thumb to push the left side of the throttle control lever.
NOTE: Always bring your scooter to a full stop before changing direction from forward to reverse,
or from reverse to forward.
To drive in reverse use either of the following:
•
Use your left hand fingers to pull back on the left side of the throttle control lever.
•
Use your right thumb to push the right side of the throttle control lever.
When the throttle control lever is completely released, it automatically returns to the center “stop”
position and engages your scooter’s brakes, bringing you to a complete stop. You will hear a
“click” when the brake engages.
Battery gauge
This meter (see Fig. 3) shows the amount of voltage in your scooter’s batteries.
•
Green indicates a full charge on the batteries.
•
Yellow indicates caution and approximately a one-half charge of the batteries.
•
Red indicates that the batteries have less than one-half of a charge remaining.
See section X. “Care and Maintenance” for instruction concerning charging the batteries.
NOTE: Your scooter will automatically turn itself off if the battery output falls to/or below 17.5v
Finger Tip Tiller Adjustment Lever
The Tiller on your scooter employs a pneumatic piston to provide you with infinite tiller angle
settings for your driving comfort.
•
Use one hand to grasp a handgrip.
•
Pull on the release lever and position the tiller at a comfortable and safe operating angle.
•
Release the tiller adjustment lever. It will automatically lock the tiller at the selected angle.
CONTROL OPTIONS
Your authorised dealer can reverse the throttle control lever controls so that when you pull on the
left side of the lever, your scooter will move in the forward direction, and when you pull on the right
side of the lever your scooter will move in the reverse direction.
SEATING CONTROLS
Armrest Height Adjustment
1. Loosen “Armrest Height Adjustment Knob” until you can pull it outward. See Fig. 4. Note:
The knob is retained in its housing with a spring.
2. While keeping the knob pulled, raise or lower the armrest to the desired position then
release the knob. After releasing the knob, you may have to raise or lower the armrest
until it aligns with the nearest locking position.
3. Tighten the height adjustment knob.
Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the adjustment knobs at the rear of the seat.
2. Slide the armrests in or out to the desired width. See Fig. 5.
3.
Tighten the adjustment knobs.
Seat Height Adjustment
To adjust the seat height:
1. Remove the seat by raising the lever and lifting the seat straight up.
2. Set the seat aside.
3. Remove the bolt, nut, & washer that hold the seat post in the seat pedestal. See Fig 6.
4. Position the seat post at the desired height while aligning the holes in the seat post and the
seat pedestal.
5. Reinstall and tighten the nut, bolt, and washer. The bolt must be installed from the back of
Summary of Contents for ZENER
Page 1: ...Owner s Manual ZENER...
