Monarch Zener Owner’s Manual v2. © Scooters Australia 2017.
16
Disconnecting the Front and Rear Frame
1. Pull up on the T handle next to the seat post. Pulling up on the T handle will separate the
front and rear section.
2. Your scooter is now fully disassembled. See Fig. 14.
ASSEMBLY
The scooter is easy to assemble. Make sure the key is out of the key switch before assembling
your scooter.
Connect the frame sections.
1. Position the front and rear sections of the frame as shown in Fig. 15 so that they align
properly.
2. Pull up on the T handle to lift the front section.
3. Once the frame hooks are properly aligned (See Fig. 16), push down on the seat post to
secure the frame together. You will hear and feel a positive “snap” sound to confirm that
the front and rear frames are connected.
4. Undo the Velcro straps from around the tiller and raise the tiller.
Battery Installation.
1. Install the batteries onto the scooter.
2. Reconnect the batteries. See Fig 13.
3. Wrap the hook and loop strap around the battery and the battery harness. See Fig. 17.
Figure 14. (with low back seat)
Figure 15.
Figure 16.
Figure 17.
Summary of Contents for ZENER
Page 1: ...Owner s Manual ZENER...
