Drain/Waste Water Connection
Prior to installing the drain connector, please inspect drain pipes for damage, frailty, or wear.
Drain saddle valves are designed to be installed on standard 1.25 and 1.5” OD drain pipe.
Install drain saddle valve above (and before) the trap and on the vertical or horizontal tailpiece.
Never install a drain saddle valve close to the outlet of a waste disposal or plugging of the RO drain line will occur.
Procedure:
1. Position the threaded half of the drain saddle valve at the selected location and mark for the opening.
Tip: Mark outline around top and bottom of drain saddle before removing for drilling as this helps reposition at No3 below.
2. Drill 1/4” hole at the mark through
this
side of the pipe only
.
3. Position both halves of the drain saddle on the drain pipe so threaded opening lines with the hole.
4. Secure the drain saddle firmly using the nuts and bolts provided.
5. Slide compression nut over ¼” black tubing.
6. Push in insert then tighten nut on drain saddle thread to seal.
Pure Water Connection on appliance
Storage Tank required?
Accompanying the unit will be a selection of speedfit connections suitable for ½” and ¾” male threads for POU. All of them
terminate at 3/8” speedfit to suit the grey flexible tubing with the unit.
Simply ‘mix and match’ these fittings to get the desired connection you require.
Additionally there will be enclosed speedfit connectors for the main Connection Point.
There is also supplied a white 3/8” x 3/8” speed fit isolating valve that can be used to isolate the storage tank/appliance
during general maintenance.
On every speedfit connection used, chamfer edge of tubing to ensure internal ‘o’ ring in speedfit is not damaged.
If stored water is required then Monarch offers a range of storage tanks for use with the ROF700. All units are designed for
drinking water use so can be used on any mains water application. All tanks come complete with connection to 3/8” speedfit.
Simply cut in the 3/8” speedfit tee (supplied) at the position marked on the FLOW DIAGRAM FOR ROF700 between the
PERMEATE Connection Point and the appliance and run 3/8” grey tubing from this tee to the storage tank.
Storage Tanks:
24, 55 and 80 litre storage tanks are currently available. Additional sizes available on request.
Please only allow 60% of the tanks rated capacity for actual water available.
