Monaco LaPalma, Owner'S Manual

Page: 181 / 366

4 • 181
Appliances
Helpful Hints:
It is a good idea to replace all light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce the number of
times you need to open the unit to replace light bulbs.
To Replace the Bottom Light Bulbs Which Generate the Flames and
Embers:
Bulb requirements: Quantity of 4 clear chandelier or candelabra bulbs
with an E-12 (small) socket base, 60 watt rating. Example GE 60BC or
Phillips 60 CTC.
Do NOT exceed 60 watts per bulb.
• Lift up front edge of log until it clears the front tabs. Pull out
until the rear tab clears the back ledge, then lift out.
• Examine the bulbs to determine which bulbs requirereplacement.
• Hold the socket while unscrewing the bulb.
• Hold the socket while screwing in the new bulb.
• Replace the log by pushing it down and in until it rests against
the mirror.
To Replace the Top Bulbs Which Illuminate the Log Exterior:
Bulb requirements: Quantity of 2 clear chandelier or candelabra bulbs
with an E-12 (small) screw base. Please refer to the label adjacent to the
upper lights for the correct wattage for your model.
Do NOT exceed 15
watts per bulb.
• Examine the bulbs to determine if they need replacing.
• Hold the socket while unscrewing the bulb.
• Hold the socket while screwing in the new bulb.
To Reassemble Light Bulb Area:
• Replace the glass and hold it in place at top.
• Fasten retaining clip to hold glass in place.
Glass Cleaning:
The glass is cleaned in the factory during the assembly operation. During
shipment, installation, handling, etc., the glass surface may collect dust
particles; these can be removed by buffing lightly with a clean dry cloth.
To remove finger prints or other marks, the glass can be cleaned with a
damp cloth using a good quality household glass cleaner. The glass should be
completely dried with a lint free cloth or paper towel. Wait until it is time to
change the light bulbs to clean inside glass surface.
CAUTION: Do not use abrasive cleaner on glass surface or
spray liquids directly onto any surface.
2004 • LaPalma