Monaco LaPalma, Owner'S Manual

Page: 151 / 366

3 • 151
Exterior & Interior Care 2004 • LaPalma
• Open cabinet doors and drawers. Inspect for water leaks at
joints or fittings. Repair as necessary.
• Operate all 12 Volt lights and accessories. If something
does not work there may be a bad 12 Volt circuit breaker or
blown fuse.
• Install new batteries in battery operated safety detectors or
devices. Test the carbon monoxide, LP-Gas and smoke
detectors for proper operation.
• Check that the monitor panel is functioning properly.
• Inspect the 120 Volt electrical system which includes the
power cord, inverter/converter all outlets and exposed
wiring.
NOTE: Prepare the generator for operation following the
instructions in the Generator Manual.
• Start and run the generator.
• Confirm that the batteries are charging. Operate the 120
Volt appliances and air conditioners. If an electrical item or
appliance is not functioning properly, contact the dealer or
an authorized service center to have it evaluated.
• Have a qualified technician inspect the LP-Gas system and
perform an LP-Gas leak test. The leak test should also
include an LP-Gas regulator adjustment (if needed). The test
can also verify if the regulator is faulty and should be
replaced. Have the LP-Gas tank inspected.
• Operate each LP-Gas appliance. Observe all burner/pilot
flames for proper color and size.
• Inspect and clean the interior.
• Check the sealant around all roof and body seams and
windows. Reseal if necessary.
• Lubricate all the exterior locks, hinges and latches with a
graphite lubricant.
• Check the windshield wiper blade condition. Check the
wiper/washer operation.
• Wash and wax the exterior. Check the body for scratches or
other damage; touch up or repair as necessary. Flush the
underside thoroughly.
• Run through the operational checks for steering, brakes,
engine and transmission. Operate the motorhome slowly
during these checks to allow sufficient circulation of fluids
and resetting of the components.
• If desired, have the dealer or repair center double-check
preparation to make any necessary adjustments and/or
correct defects.