Monaco CAYMAN 2007, Manual

Page: 103 / 226

EQUIPMENT - 5
CAYMAN 2007 99
To operate the Stepwell Cover:
1. Turn ON the Battery Cut-
Off switch.
2. Press and hold the Step
cover switch to the
desired direction. Release
the switch to stop
movement.
CAUTION:
When operating the
stepwell cover, make sure
there are no pets, shoes or
other obstructions in the
stepwell area. DO NOT
operate the stepwell cover
while standing in the
stepwell area.
Assist (Grab) Handle
The assist handle is made of clear acrylic.
Though normally UV resistant, the assist handle
can be weakened or damaged by using improper
cleaning agents. This will cause small stress
fractures that can eventually lead to failure of
the assist handle. Approved cleaning solutions
are mild soap and water solution only. Cleaning
agents containing alcohol, such as commonly
found in window cleaners, or cleaning agents
containing petroleum distillates will damage the
assist handle. DO NOT use waxes, plastic or
upholstery conditioners as these substances can
also cause damage.
ENTRY DOOR
The entry door incorporates three separate
seals to eliminate wind noise during travel.
The door uses two separate locks for safety
and security: the door handle and a dead bolt.
The door handle incorporates a primary and
secondary latching system used to ensure secure
and safe latching. Adjustments can be made to
help maintain entry door performance.
Latch Adjustments
Adjusting the Entry Door Latch:
Determine which bolt needs adjustment.
Observe the latch and strike bolt
alignment while slowly closing the
entry door. DO NOT attempt to latch
if alignment is off. If the alignment is
correct, allow the latch to catch in the
fi rst (primary) position only.
The latch should move to the second
position with just slight pressure applied
to the entry door. Upper and lower
latches should be evenly timed. Press on
the entry door to see if there is further
movement of the door.
The handle should operate with little
effort to open the entry door. Excess
amounts of pressure indicate the bolts
are set too far back.




With an Allen Wrench, loosen
the movable strike bolt. Make all
adjustments in small increments. Tighten
the bolt fi rmly after making adjustments.
The bolts should have slight up and
down movement for vibration control in
travel.
Test the operation of the dead bolt lock
to ensure proper function.
Apply silicone weekly to the entry door
rubber gaskets to prevent squeaking
while the motorhome is traveling. Use
a one inch sponge paint brush, sprayed
with silicone, for easy application.
CAUTION:
When operating the entry door ensure
the dead bolt latch is fully in the unlock
position prior to closing the entry door.
Failure to do so can result in damage to
the dead bolt and/or entry door.
Screen Door
Changing the Glass in the Screen Door:
The screen slider is Lexan and can be
bowed for removal and replacement.
Replace with new Lexan and reverse the
procedure.





Located on
center dash
console.
080375i