Page 8 of 22
Rev B
–
Dec 2009
FLOOR REQUIREMENTS FOR MODEL SL02
These notes are for your guidance prior to installation.
1.
It is the user
’
s responsibility to provide a satisfactory site area.
2.
The floor should be a single reinforced concrete slab.
Min concrete thickness = 100mm
Min plan dimensions of 3800mm x 2200mm
Prepared base 100mm thickness of quarry rubble compacted to 95%
SL81 reinforcement mesh
Min thickness of concrete above mesh = 65mm
25Mpa concrete
3.
For correct installation of the Scissor Lift Hoist, the floor must be flat and level
at the anchorage points. A level tolerance between bases of 8mm is allowable
and 10mm front to rear. Check with straight edge and spirit level.
4.
Recommended anchor bolts are expansion sleeve type anchors 20mm
diameter with a minimum length of 82mm.
Use the manufacturers recommended installation procedures.
NOTE: Some authorities do not approve expanding type anchorage devices.
5.
If there is any doubt about the quality of the floor, a replacement slab should
be installed. Use a qualified person to design the replacement slab.
6.
No liability for any damages will be accepted should you install the hoist on an
unsuitable floor.
Summary of Contents for SL02
