Molnar SL02, Installation Operation & Maintenance, Page: 10 / 22

Page 10 of 22 Rev B
–
Dec 2009
MAINTENANCE
DAILY
Check safety mechanism is functioning correctly.
WEEKLY
Clean the bottom tracks and safety with compressed air (do not use water)
MONTHLY
1. Check safety mechanism operation.
2. Check condition of shafts, shaft locks and bushes.
3. Check overall cleanliness.
4. Clean roller tracks, spray rollers and safety toggle shafts with an aerosol based
multi purpose lubricant.
6 MONTHLY
1. Check condition of extensions and lubricate with an industrial grade type silicone
based spray.
2. Check oil leaks from cylinders.
3. Check oil leaks at pipe joints.
4. Check anchor bolts.
5. Lubricate top and bottom roller side guides and tracks with an industrial grade
type silicone based spray.
6. Lubricate safety air cylinders (two drops of light oil down the inlet fitting).
YEARLY
Service and safety inspection on the hoist must be performed by a competent
person. This inspection must be recorded. If the 12 monthly service and safety
inspection is not performed, the warranty is null and void.
NOTE: Yearly service must include removal of rollers to inspect, clean and lubricate
bushes and pins.
2 YEARLY
Hydraulic oil and filter should be replaced. Fill Oil Tank to Oil Level Line with Shell
Tellus T46 oil, Mobil DTE25 oil, Castrol Hyspin AWH46 oil, BP Bartran HV46 oil or
equivalent.
Check and clean inline air filter element, access to the element is made by
unscrewing the large hex nut in the inlet end of the filter body.
NOTE: After cleaning workshop floor or hoist, to maintain hoist efficiency we advise
to lubricate roller bearings and safety toggle shafts, as per monthly maintenance
instructions point 4.