IDT Ribbon Cable Hand Tool Module
Doc No: ATS-621002000 Release Date: 09-25-98
UNCONTROLLED COPY
Page 2 of 4
Revision: F
Revision Date: 08-13-08
CABLE GUIDES
Figure 2
62100-2000 MODULE
END STOP
LOCKING SCREW
ADJUSTABLE
STOP
CABLE STOP
11-31-3337
POWER ADAPTER
RATCHET
RELEASE PAWL
Figure 1
(HANDLE AND ADAPTER ARE NOT INCLUDED)
62100-2000
MODULE
63600-0478
PISTOL HANDLE
SIDE LOAD ANVIL
WITH PEGS (11-32-8177)
INCLUDED WITH
62100-2000
62100-2000
MODULE
11-31-3337
ADAPTER
STOPS
Figure 3
10 CIRCUIT
CONNECTOR
(SMALLEST)
50 CIRCUIT
CONNECTOR (LARGEST)
Figure 4
ADJUSTABLE
STOP
M2.5 SHCS
DESCRIPTION
Installation
1.
Replace the anvil on the power adapter with the 11-32-8177 anvil, included in this kit.
2.
Next, install the 62100-2000 IDT Ribbon Cable Module into the 11-31-3337 Power Adapter.
3.
Then install the 63600-0478 Pistol Power Handle to the Power Adapter by following these steps:
a.
Rotate the two (2) stops on the power adapter pegs so they are in line with the pegs. See Figure 3.
b.
Slide the hand tool module onto the power adapter.
c.
Rotate the stops back into stop position. See Figure 1.
d.
Align this assembly with the handle; push the adapter down onto the handle until the stop on the adapter
is firmly seated in the groove on the handle.
Nest Adjustment
1.
To adjust the nest for correct connector size, loosen the M2.5 SHCS in the adjustable stop and slide the stop
away from the end stop.
2.
Place the proper connector into the nest against the end stop. See Figure 4.