Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638276900 - HAND CRIMP TOOL
Contact us: [email protected] Website: www.integrated-circuit.com
Hand Crimp Tool for 1.25mm (.049") Pitch Wire-to-Board Crimp Terminals
Doc No: ATS-6382769HM
Release Date: 12-16-14
UNCONTROLLED COPY
Page 2 of 6
Revision: A
Revision Date: 12-16-14
CRIMP SPECIFICATION
After crimping, the crimp profiles should measure the following.
Terminal Series No.
Bell mouth
Conductor Brush
mm
In.
mm
In.
504185
0.10-0.30 .004-.012 0.10-0.30 .004-.012
Terminal Series No.
Bend up Bend down
Twist Roll
Seam
Seam shall not be
open and no wire allowed
out of the crimping area
Degree Max.
Degree Max.
504185
2
3
4
6
Terminal
Series No.
Wire Size
Conductor
Insulation
Pull Force
Minimum
Profile
Crimp Height
Crimp Width
(Ref)
Crimp Height
(Max)
Crimp Width
(Max)
AWG mm
2
mm
In.
mm
In.
mm
In.
mm
In.
N
Lb. 26 28 30
504185
26
-
0.54-0.59 .021-.023 0.88 .034 1.20
.047 0.90 .035 9.8 2.20 X
28
-
0.49-0.54 .019-.021 0.88 .034 1.19
.047 0.90 .035 9.8 2.20
X
30
-
0.46-0.51 .018-.020 0.88 .034 1.09
.043 0.90 .035 4.9 1.10
X
Tool Qualification Notes:
1.
Pull Force should be measured with no influence from the insulation crimp.
2.
The above specifications are guidelines to an optimum crimp.
Notes:
1.
This tool should only be used for the terminals and wire gauges specified on this sheet.
2.
This tool is not adjustable for crimp height; however crimp force is adjustable (See instructions above).
Variations in tools, terminals, wire stranding, and insulation types may affect crimp height.
3.
This tool is intended for standard conductor sizes. It may not give a good insulation crimp support for all
insulation sizes.
4.
Molex does not repair hand tools (see warranty above). The replacement parts listed are the only parts
available for repair. If the handles or crimp tooling is damaged or worn, a new tool must be purchased.
5.
Pull force should be used as the final criteria for an acceptable crimp. Pull force is measured with no
influence from the insulation crimp. The insulation should be stripped long (1/2 in.) so the insulation grips
on the terminal do not grip the wire insulation or the conductor. Refer to Molex Quality Crimping
Handbook 63800-0029 for additional information on crimping and crimp testing.
6.
Molex does not certify crimp hand tools.
3 / 7
3 / 7
