Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638257400 - HAND CRIMP TOOL
Contact us: [email protected] Website: www.integrated-circuit.com
Tool Kit for 250 Slip-in Receptacle Terminals
Doc No: ATS-6382574HM Release Date: 05-20-13
UNCONTROLLED COPY
Page 4 of 8
Revision: A
Revision Date: 05-20-13
SWING OPEN
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
LOCATOR
TERMINAL
IN PLACE
Figure 4
LOCATOR LATCH
IN OPEN POSITION
Figure 6
WIRE IN TERMINAL
JAWS
PARTIALLY
CLOSED
WIRE AGAINST
WIRE STOP
HANDLE
OPEN
LOCATOR
CLOSED
Figure 5
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
Figure 7
WIRE
INSULATION
PUNCH
CONDUCTOR
ANVIL
LOCATOR
INSULATION ANVIL
WIRES AGAINST
LOCATOR STOP
CONDUCTOR
PUNCH
TERMINAL
7.
Insert the proper wire over the terminal.
8.
Gently touch the wire stop with the end of the wire. See Figure 6 and 7.
9.
Compress the terminal by squeezing the tool handles
until the ratchet mechanism cycle has been completed.
Release handles to open the jaws.
10.
Remove the crimped terminal from the terminal locator
by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
11.
Visually inspect the crimped terminal for proper crimp
location.
Note
: The tamper proof ratchet action will not release the
tool until it has been fully closed.
For the Battery Power Tool:
1.
Cycle the Battery Power Tool to crimp the terminal to
the wire.
2.
Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
3.
Visually inspect the crimped terminal for proper crimp location.
5 / 9
5 / 9
