Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638257400 - HAND CRIMP TOOL
Contact us: [email protected] Website: www.integrated-circuit.com
Tool Kit for 250 Slip-in Receptacle Terminals
Doc No: ATS-6382574HM Release Date: 05-20-13
UNCONTROLLED COPY
Page 2 of 8
Revision: A
Revision Date: 05-20-13
▲
Insulation Crimp Note
:
Due to the terminal’s insulation grip design
and/or insulation diameter range, this tool
uses “overlap” form geometry in the
insulation punch. This produces an overlap
insulation crimp (A620 – compliant). While
the insulation punch profile may appear
“lopsided”, this is a normal condition for this
tool. See figure to the right. (Some tools with
multiple crimp pockets may not have the
“overlap” profile on all pockets).
CONDITIONS:
After crimping, the conductor profiles should measure the following (See notes below).
Terminal Series No.
Wire Size
Conductor Crimp
Profile
Height
Width (Ref)
AWG mm
2
mm
In.
mm
In.
A
B
C
35725
10
5.25 2.45-2.55 .096-.100
3.60
1.42
X
12
3.30 2.05-2.15 .081-.085
3.60
1.42
X
14
2.00 1.75-1.85 .069-.073
3.60
1.42
X
Terminal Series No.
Wire Size
Insulation Crimp
Pull Force Minimum
Height (Ref) Width (Ref)
AWG mm
2
mm
In.
mm
In.
N
Lbs
35725
10
5.25 5.30
.209 5.00 .197
353
79.4
12
3.30 4.50
.177 4.70 .185
294
66.1
14
2.00 4.40
.173 4.40 .173
275
61.8
Tool Qualification Notes:
1. Pull Force should be measured with no influence from the insulation crimp.
2. The above specifications are guidelines to an optimum crimp.
Note:
A crimp height chart is provided with this manual as Reference Only. Due to the wide range of wires, strands,
insulation diameters, and durometers, actual crimp height measurements may very slightly. An occasional,
destructive, pull force test should be preformed to check hand tool crimp. Pull Force value must exceed the
minimum pull force specifications listed.
CAUTION:
Install only Molex terminals listed above with this tool. Do not crimp hardened objects as damage
can occur to the tool or die.
INSTALLATION
To install the Tool Kit into the Power Crimp Head follow the steps below:
OVERLAP
INSULATION
CRIMP
OVERLAP FORM GEOMETRY
ANVIL
PUNCH
WIRE
3 / 9
3 / 9
