Mohawk TR-33, Manual, Page: 3 / 87

3
MOHAWK MODEL TR-33/35/50/75/33WT/35WT/50WT/70WT
APPENDAGE:
(7/10/2012)
LIFT ENVIRONMENT:
Mohawk prohibits the outdoor installation of this standard lift, which is APPROVED FOR INDOOR USAGE ONLY,
in a normal garage type environment. Any concerns in applications that expose the lift to additional environmental
effects, such as paint booths, wash bays, outdoors, high or low temperatures, etc. must be addressed to our
engineering department, where provisions could/may be made to the lift to accommodate the area of use. Our
engineering department must be made aware in advance of these conditions and any additional code requirements that
must be met.
Also, the foundation for which this lift must be installed on must comply to the minimum specifications as set forth in
this manual. Any drainage slopes in the bay where the lift is to be installed must be directed away from the posts to
prevent water accumulation at the post bases.
Standard foundation flooring and anchorage specifications are contained within this manual. For installation within a
seismic area, a qualified person must be consulted to address seismic loads and other local or state requirements.
ACCESSORIES:
All accessories (i.e. jacking beams, etc.) supplied with this lift are to be used on this lift only. Accessories
from other lifts are not acceptable and could result in injury to the user.
If attachments, accessories or configuration modifying components are used on this lift and, if they are not
certified for use on this lift, then the certification of this lift shall become null and void. Contact the
participant (
02+$:./,)76//& .) for information pertaining to certified attachments, accessories or
configuration modifying components.
LOCKOUT/TAGOUT REQUIREMENTS:
The start switch provided with this unit must not be used as a primary disconnecting means. A separate
disconnecting means must be provided in accordance with all applicable codes. It is the responsibility of the
owner/user of this unit to provide a proper lockout/tagout device for this unit before or during installation in
conformance to ANSI Z244.1 and any local/state/national electrical codes and any OSHA regulations.
JACKING BEAMS:
Loading of the jacking beams or combinations of jacking beams above the rated capacity of the lift itself
could result in personal injury to the operator and/or damage to the lift and/or vehicle. The load rating of
any jacking beam or combination of jacking beams on this unit must not exceed the rated capacity of the
lift.