Mohawk TR-33, Manual

Page: 17 / 87

MOHAWK MODEL TR-33/35/50/75/33WT/35WT/50WT/70WT
17
INSTALLATION INSTRUCTIONS
ALIGN THE CROSS RAIL MOUNTING HOLES WITH
THE MOUNTING HOLES ON THE CARRIAGE ON
POST NUMBER ONE. WHEN THE CROSS RAIL IS IN
PLACE, INSERT AND HAND TIGHTEN THE EIGHT
3/4 - 16 NF X 2 - 1/2 IN BOLT AND 3/4 - 16 NF NYLON
LOCK NUT.
ALIGN THE CROSS RAIL MOUNTING HOLES WITH
THE MOUNTING HOLES ON THE CARRIAGE ON
POST NUMBER TWO. WHEN THE CROSS RAIL IS IN
PLACE, INSERT AND HAND TIGHTEN THE EIGHT
3/4 - 16 NF X 2 - 1/2 IN BOLT AND 3/4 - 16 NF NYLON
LOCK NUT.
FULLY TIGHTEN THE SIXTEEN CROSS RAIL
MOUNTING BOLTS TO 420 FOOT POUNDS.
CONNECT THE TWO EQUALIZING CHAINS TO THE
TOP OF POST ONE AND TWO.
TIGHTEN THE NYLON LOCK NUT SO THAT THE
THREADS OF THE CHAIN CONNECTOR PROTRUDE
PAST THE NYLON BY AT LEAST THREE THREADS.
PLACE THE MAIN AND OFF SIDE TRACK INTO
POSITION ON THE CROSS RAIL. ELEVATE THE
TRACKS OFF OF THE CROSS RAIL USING THE
4 X 4 X 12 IN DUNNAGE.
NOTE
x
THE MAIN SIDE TRACK IS TO BE LOCATED ON
THE SIDE WITH THE CONTROL CONSOLE.
REFERENCE LIFT VERIFICATION SHEET
ALIGN POST THREE AND FOUR INTO PLACE ON
THE CHALK LINE LAYOUT.
POST THREE IS TO BE SET ONE FOOT OUT AWAY
FROM POST FOUR UNTIL THE CROSS RAIL CHAINS
HAVE BEEN ROUTED THROUGH THE CARRIAGES.
SET THE CROSS RAIL MARKED THREE AND FOUR
INTO PLACE BETWEEN POST THREE AND FOUR IN
THE CORRESPONDING ORIENTATION.
USING THE FISH TAPE ROUTE THE TWO
EQUALIZING CHAINS THROUGH THE CROSS RAIL.
AND CARRIAGES. LAY THE EXCESS CHAIN ONTO
THE CROSS RAIL.
WARNING
x
DO NOT CROSS OR TWIST THE EQUALIZING
CHAINS WHEN FISHING THEM THROUGH THE
CROSS RAIL. ALWAYS VERIFY THIS USING A
DROP OR FLASH LIGHT. FAILURE TO DO SO
COULD RESULT IN PERSONAL INJURY.
ALIGN THE CROSS RAIL MOUNTING HOLES WITH
THE MOUNTING HOLES ON THE CARRIAGE ON
POST NUMBER THREE. WHEN THE CROSS RAIL IS
IN PLACE, INSERT AND HAND TIGHTEN THE EIGHT
3/4 - 16 NF X 2 - 1/2 IN BOLT AND
3/4 - 16 NF NYLON LOCK NUT.
ALIGN THE CROSS RAIL MOUNTING HOLES WITH
THE MOUNTING HOLES ON THE CARRIAGE ON
POST NUMBER FOUR. WHEN THE CROSS RAIL IS IN
PLACE, INSERT AND HAND TIGHTEN THE EIGHT
3/4 - 16 NF X 2 - 1/2 IN BOLT AND 3/4 - 16 NF NYLON
LOCK NUT.
FULLY TIGHTEN THE SIXTEEN CROSS RAIL
MOUNTING BOLTS TO 420 FOOT POUNDS.
CONNECT THE TWO EQUALIZING CHAINS TO THE
TOP OF POST THREE AND FOUR.
TIGHTEN THE NYLON LOCK NUT SO THAT THE
THREADS OF THE CHAIN CONNECTOR PROTRUDE
PAST THE NYLON BY AT LEAST THREE THREADS.