3
To reassemble the
handle:
Work
backwards from
steps 3 through 1.
To install spout
O-rings:
Move to step 9.
Gently pry up on the black crown ring. Be careful not
to damage the crown ring; this will be used again
during reassembly.
9
10
Grab the spout and lift up
to remove the item from
the faucet body.
11
In the photo above, the
upper and lower O-rings
are highlighted in
orange
.
Pry each O-ring out to remove. Be careful not to damage the valve body.
Using the supplied pouch of grease, apply a thin layer of grease
to each rubber O-ring. Place a new rubber O-ring onto the black
valve body and push down until fully seated in the lowest groove.
Place the next O-ring onto the top groove in the valve body.
12
13
