background image

 

 

 
 

 

 

 

       
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Highlighted in 

orange

 are 

small tabs on 

the cartridge  

and grooves in 

the faucet. 

These must 

line up. 

 

Installation Tool Option 

Tool number: 118305 

 

Using the grey assembly tool (supplied with the faucet), pliers or wrench, 
unscrew the 1255 cartridge nut counter-clockwise and remove. 

Lift the 1255 cartridge out 
of the faucet. 

1. 

View the 1255 cartridge to find the three small tabs protruding. 
Look into the chamber of the faucet to find the location of the 
three large grooves. The grooves will accept the small tabs 
protruding from the 1255 cartridge. These tabs and grooves are 
highlighted in 

orange

 above for demonstration, but will not be 

orange on your cartridge and faucet. 

 

Insert the 1255 cartridge 
into the chamber making 
sure to line up the three 
tabs with the grooves. 

 

 

 

Use a soft brush to 
clean the inside of 
the chamber. Make 
sure no debris 
remains. 

Using the grey assembly tool, 
pliers or a wrench, tighten the 
new 1255 cartridge nut until 
snug. Next turn approximately 
90 degrees to fully secure the 
nut. 

OR 

Summary of Contents for 1255

Page 1: ...e hole in either the front or back of the handle If this hole is covered by a small plug pry the plug off to remove Next use the 3 32 Allen wrench in the hole to unscrew the Allen screw This screw does not need to be fully removed only loosened until the handle will slide off Caution Always turn your water supplies off before disassembling your faucet With the supplies turned off move your faucet ...

Page 2: ...amber of the faucet to find the location of the three large grooves The grooves will accept the small tabs protruding from the 1255 cartridge These tabs and grooves are highlighted in orange above for demonstration but will not be orange on your cartridge and faucet Insert the 1255 cartridge into the chamber making sure to line up the three tabs with the grooves Use a soft brush to clean the insid...

Page 3: ...lift up to remove the item from the faucet body 11 In the photo above the upper and lower O rings are highlighted in orange Pry each O ring out to remove Be careful not to damage the valve body Using the supplied pouch of grease apply a thin layer of grease to each rubber O ring Place a new rubber O ring onto the black valve body and push down until fully seated in the lowest groove Place the next...

Page 4: ...the spout so the tabs of the tuck under the edge of the channel The line highlighted in orange shows where the gap in the crown ring should be located To insure the crown ring is seated properly gently pull upwards on the spout If the crown ring is seated the spout will not lift off To reassemble the handle Work backwards from steps 3 through 1 Once the handle is assembled you are all done ...

Reviews: