Moeller DP-16DI-ECO, Hardware And Engineering, Page: 10 / 151

About this Manual
6
05/01 AWB2700-1384GB
Notes Concerning Planning /
Installation of this Product
Technical Safety For a 24 V-supply, the low-voltage range must be electrically
isolated.
Connection and signal lines must be installed in such a way that
inductive and capacitive stray pick-ups can cause no disturbance to
the automated function.
Automated installations and their operating elements have to be
installed in such a way that they are protected from unintentional
operation.
In order to avoid that an open-circuit on the signal side does not
cause an unexplained fault in the automated installation, all safety
instructions concerning hardware and software of I/O-couplings
must be complied with.
Warning!
All specific safety measures and accident protection guidelines
have to be considered carefully without exception.
If the equipment is to be permanently installed and it has no
power isolation switch/circuit breaker, then a power isolation
switch/circuit breaker must be installed into the building. The
installation has to be connected to a protective conductor.
If the equipment is to be connected to a power supply, the local
supply voltage must be checked to ensure the correct supply
voltage range is selected.
Warning!
In areas where errors inside the automated facility can cause
severe personal injury or property damage, external precautions
must be met to ensure protection to the operation of the facility,
even in the event of an error or malfunction, by using
independent limit switches, mechanical locking devices, etc.