4
Setup:
It is always recommended to remove all tubes before shipping the unit. Be sure that the ELYSE
DAC is NOT connected to AC power and that the power plug is disconnected from the unit and
wall outlet. Use supplied 5/64” hex driver to remove four lid screws in top panel and install (2)
6922 signal tubes in 9-pin ceramic tube sockets and the supplied 5AR4 rectifier tube in the
ceramic ‘octal’ tube socket. Align tube pins with socket and gently but firmly press the tubes
down into socket until seated.
After all tubes are installed, replace lid and secure with four screws. Only after this, should the
ELYSE DAC power cord be connected.
DO NOT POWER UNIT ON UNTIL LID IS ENTIRELY FASTENED. VERY HIGH
VOLTAGES ARE PRESENT INSIDE UNIT DURING OPERATION AND IT IS
CRITICAL THAT THE PREAMP ENCLOSURE NOT BE OPEN WHEN UNIT IS
POWERED ON. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY OR
DEATH.
Summary of Contents for ELYSE Tube DAC
Page 12: ...12 ...
