28
10. Setting up the Receiver
The receiver offers the possibility to connect up to 6 servos.
Only 4 of the 6 channels can be used in connection with this 4-channel remote control system!
• When connecting servos and speed or flight controllers, always make sure to pay close attention to the correct
polarity of the plug connectors.
• The wrap connection for the positive lead (yellow, white or orange, depending on the manufacturer) must be con-
nected to the upper pin contact.
• The wrap connection for the negative lead (black or brown, depending on the manufacturer) must be connected to
the bottom pin contact.
a) Assignment of Receiver Channels to the Control Levers
The factory setting is “Mode 2”.
Channel
Function
Control lever
Control direction
CH 1 (channel 1)
Aileron
right
Left/right
CH 2 (channel 2)
Elevator rudder
right
Forward/reverse
CH 3 (channel 3)
Throttle / speed
left
Forward/reverse
CH 4 (channel 4)
Rudder
left
Left/right
CH 5 (channel 5)
Not available
-
-
CH 6 (channel 6)
Not available
-
-
b) Installing the Receiver
Installation of the receiver depends on the model. For this reason, you should always follow the recommendations of
the model manufacturer regarding receiver installation.
Regardless of the model, you should always try to install the receiver so that it is protected from dust, dirt, moisture and
vibration in the best possible way.
Two-sided adhesive foam (servo tape) or rubber rings that hold the foam-wrapped receiver securely in place are
suitable for fastening.
