B
A
C
D
E
F
G
SER
VICE
25
E4 Placing the Infill & Burners
The infill is specific to the different fuelbed options (see section F). The side burners are made LH and
RH and can only be installed in this position with a go - no go tab system (seen below).
Ensure that the gas jets and burner collars are appropriate to the gas type using the table below. For
gas type conversion, proceed to “E5 Gas Type Conversion” on page 26pg26.
Natural Gas
Propane
ULPG
Jets
Collars
Jets
Collars
Jets
Collars
Centre Burner
2.10mm 2 xØ4.5mm 1.2 mm
Spacer
1.2 mm
Spacer
Side Burners
1.8 mm
1 xØ3.5mm
1.05 mm 2xØ13mm 1.05 mm 2xØ13mm
Place the centre burner first, which slides into place from the left. Place the outer burners next, which
slide towards the centre of the fireplace. Place one end of the infill in place first, taking care not to
scratch the firebox paint or the black glass. Gently lower the other edge of the infill into place, insuring
that the pilot shroud sits around the pilot. Attach the four screws circled in the diagram bottom below.
To remove the infill and burner, reverse the procedure above.