B
A
C
D
E
F
G
SER
VICE
27
E5 Gas Type Conversion
THIS APPLIANCE IS CONFIGURED TO OPERATE ON NATURAL GAS (NG). If gas type
conversion is not required then skip to the next section.
Your gas fire has been supplied with the necessary parts for gas conversion. Follow the steps on the
following pages to change from NG to ULPG/Propane or vice versa.
WARNING: The regulator that is supplied with the fire MUST NOT BE REMOVED.
Removal of the regulator, or replacing it with one not intended for use with this Escea fire, will void the
limited appliance warranty.
Turn off power and gas first.
Step 1:
Remove the Infill first by removing the 4 screws circled below, then remove the burners by
sliding them in the direction of the arrows below, start with both sides before removing the center
burner.
Step 2:
Change the burner jets with the jets supplied in kit set (see table on next page).
Step 3:
Replace the pilot jet (see tables below).
Note: Ensure the pilot jet is joined up to the olive before
inserting the jet into the pilot assembly (as shown below).
Step 4:
Screw out the nylon adjuster screw inside the regulator to remove the existing spring. Replace
the spring with the purple spring supplied in the conversion kit and reassemble the regulator.
Step 5:
Stick the new gas type label supplied in the kit set on the underside of the tray hatch. Ensure
the serial number and date of manufacture are still visible. Write your name, company (if appropriate)
and date of conversion on the new label with permanent marker.
Step 6:
Re
place the hatch (removed in step 1). Reconnect the 4 pin connector to the valve. Take care
not to over tighten screws.
Step 7:
The burner tubes on the underside of all burners have convertible aeration collars. Ensure the
aeration collars on all burners are correctly fitted on each burner tube.
Natural Gas
Burner Jets
Burner Collars
Middle
Burner
Side
Burners
Pilot
Middle
Burner
Side
Burners
KS1460
Single/Double 2.10mm
1.8mm
#37
2x 4.5m
hole
1x 3.5mm
hole
ULPG/Propane
Burner Jets
Burner Collars
Middle
Burner
Side
Burners
Pilot
Middle
Burner
Side
Burners
KS1140 Single/
Double
1.2mm
1.05mm
#27
Spacer
Collar
2 x 13mm
holes
