38
/98
T24S System Manual: Connecting The Door Station And Modules
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
2.6 Replacing The MicroSD Card
The camera module is factory-fi tted with a ready-to-use 4 GB MicroSD card. However, the
system also supports other MicroSD cards with up to 32 GB storage capacity. To remove,
insert or replace a MicroSD card, separate fi rst the camera module from the door station.
To avoid data loss, be sure to deactivate MicroSD card recording in the camera software
and reboot the MOBOTIX camera before removing the card.
Caution
A MicroSD card may only be removed from the camera after you have deactivated
Recording to SD Card and rebooted the camera. Failing to do so may lead to loss
of data!
2.6.1 Removing The MicroSD Card
1.
Deactivate recording:
Recording to the MicroSD card must be deactivated (Admin
Menu > Storage on External File Server / Flash Device). If the MicroSD card recording
is still active, deactivate recording, and reboot
the camera. For more information, see the
MicroSD Card Recording section in chapter 3.
2.
Remove the camera from the Vario frame:
Insert the special key included with the Siedle
installation frame into the small opening
under the camera module and release
the camera from the installation frame by
pushing the key in.
If the anti-theft protection accessory has
been installed, it must fi rst be switched off
at the controller before the camera module
may be removed as described.
3.
Remove the cable:
Release the RJ45 con-
nector on the black camera patch cable
from the terminal board.
Remove the MxBus connector:
Pull the
MxBus connector from the back of the
camera housing.
The special Siedle key
is included with the
installation frame
