152
/160
S15 Camera Manual: Operating the Camera
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
3. Once you have found the proper pattern, keep any one of the buttons at the center
pressed until the LEDs are flashing repeatedly in a sequence. Next, the
OK
and letter
buttons light up green and the
ESC
button lights up red.
4. Insert the function and bell buttons as required.
5. Train the admin card. All three LEDs are now green.
6. Train the user cards as required.
You can find detailed information on installing and operating the BellRFID module in the
document
BellRFID Quick Installation (
www.mobotix.com
> Support > Manuals
).
Finalizing the Setup
The most important functions of the door station are now available. Even the mailbox has
been pre-configured. You can make the remaining adjustments – just like with a “regular”
IP Video Door Station – without a computer using a Grandstream video phone as remote
station or with a computer using MxEasy or a web browser.
3.7.3 Setting Up an S15 as a Door Station
As an alternative to using the auto configuration of the camera as described in the last
section, you can also use MxEasy to configure an S15 as a door station (just like when
setting up an IP Video Door Station). Similar to the process above, all components need
to have been wired and connected beforehand.
Note
This functionality is supported by MxEasy version
1.6.1
and higher. The camera needs
to run on a software (firmware) version
4.1.9
or higher.
In this case, the MxEasy
Wizard
executes the auto configu-
ration and guides you through the setup of the attached
modules, the bell button profiles, etc. in a step-by-step
manner.
For additional information on this topic, see the
MxEasy User
Manual 1.6.1 in Section 2.3.3, «Special Case: Integrating an
IP Video Door Station» (
www.mobotix.com
> Support >
Manuals > Software > MxEasy
).
