8
MV2400 Extender Wireless Installation
2
- Choose a location near the power source to drill a hole in the RV Ceiling to install the Extender Switch.
This should be near or directly below where the MV2400 Extender Housing will be installed on the roof.
1
- Locate a 12V(+) power source on the RV Ceiling (such as exhaust fan or light input power) to power
the MV2400 Extender. This power source needs to be accessible to connect to the MV2400 power wires
as shown in
Step 8
.
When MV2400 Extender is not in use, a switch is needed to turn
off the MV2400 Extender so that the RV battery is not drained.
DO NOT
drill a hole into the roof
UNTIL
you have verified the exterior
mounting location of the MV2400 Extender Housing. Be sure to find
a location to mount the housing that is flat and away from large items
like air conditioners that may cause interference.
2
3
Hole to
MV2400
Extender
Extender
Switch
3
- In the determined location near the Extender Switch, drill a hole into the roof to later connect the
yellow and black wires from the Extender Switch to the MV2400 Extender.
1
Power
Source (i.e. fan)
Hole Option A
(Inside RV)
(Rooftop)
CAUTION
