FEATURES:
5 in 1 Multipurpose Power Source. The unit provides: 16.8V 2200 mAh Lithium ion Rechargeable Battery.
Vehicle Boost Starter, 12VDC Power Port covered receptacle, 5V - 2100 mA USB Power Port, DC Plug
Vehicle Boost Start and 12V DC Charger through the vehicle 12 Volt DC cigarette lighter socket - Vehicle
Battery Charge Level Diagnostic Module. Battery Charge Level Indicator with Digital Display LCD.
Built-in 12V DC Quick Charger through Charge/Boost DC Plug. Includes 110V AC Charger.
SPECIFICATIONS:
Built-in 16.8V 2200 mAh Rechargeable Lithium ion Battery.
12 VDC 10 A Rated Accessory Port with Protective Cover.
USB 5V - 2100 mA Output Port.
25A Fuse - Vehicle Boost Start DC Plug.
CHARGING INSTRUCTIONS:
CAUTIONS
Prior to charge this device, read and understand all the related instruction indicated below. Fully
charge the unit until the Charging Indicator LED turns OFF. This product may arrive partially
charged from the factory. It is highly recommended to fully charge the BoostPak2 after purchase
and before using for the first time.
Charge the BoostPak2 if the internal battery voltage displays below 12 Volt.
Make certain that all ON/OFF Power Switches are set in the OFF position.
Do not charge the BoostPak2 unit near flammable material, open flame or any location which
accumulate flammable fumes.
Make certain the electrical outlet located in a potentially wet or moist area that is to be used to
charge this device, is protected by a Ground Fault Circuit Interrupter (GFCI).
Make sure that the DC Plug is securely attached to the Stow Bar when not in use and during the
charging period.
Do not operate the BoostPak2 12V Accessory Port or the USB Port while the unit is under charge.
CHARGE THIS PRODUCT IMMEDIATELY AFTER PURCHASE. RECHARGE AFTER EACH USE AND
EVERY TWO MONTHS.
A. AC Charging At Home with 110 Volt Charger
1. Keep the Power ON/OFF Toggle Switch in OFF position while charging.
2. Insert the AC charger round plug at the end of cable into the AC Charging Port of BoostPak2.
3. Connect the 110 Volt AC Charger into the 110 Volt AC home receptacle.
4. Fully charge the BoostPak2 unit according to the following schedules:
First time charge: 8 hours or when the Charging Indicator LED turns OFF.
Recharge and subsequent charge: 6 hours or when the Charging Indicator LED turns OFF.
5. Unplug the AC charger from the 110 Volt receptacle first and then remove the round plug from the
BoostPack2 AC Charging Port.
S
he
et
4
of
8
Model No. 2019
Stow Bar
DC Plug - Vehicle
Boost Start and
DC Charger
Pull down and detach
the DC Plug
