Mobatime ECO-M-DK, Instruction Manual, Page: 22 / 52

© MOBATIME
22 / 52 801317.00
The display shows the following:
Enter the four octets of the gateway IP
address step by step. Switch to another
octet by pushing the
<< and >> buttons.
Octets are marked by letters A , b , C
and d .
By pushing OK , the entered values are stored and the clock returns to the menu
item P22 . By pushing ESC , the clock returns to P22 without saving.
4.2.7 Submenu for setting the multicast group address
Choose the menu item P23 and then enter the submenu by pushing the SET for
setting the multicast group address. The item to be set is blinking.
The display shows the following:
Enter the four octets of the IP address step by
step. Switch to the next digit or octet respectively
by pushing the
>> button. Octets are marked by
the letters A , b , C and d .
By pushing OK , the entered values are stored and the clock returns to the menu
item P23 . By pushing ESC , the clock returns to P23 without saving.
4.2.8 Submenu for the setting of the NTP unicast synchronization
Choose the menu item P24 and then enter the submenu by pushing the SET for
setting the parameters of the NTP unicast synchronization. The item to be set is
blinking.
The display shows the following:
Set the four octets of the NTP server’s IP address
step by step. Switch to the next digit or octet
respectively by pushing the
>> button. Octets are
marked by letters A , b , C and d .
After the last octet setting, set the constant x which determines the interval of
synchronization in seconds.
By pushing OK , the entered values are stored and the clock returns to the menu
item P24 . By pushing ESC , the clock returns to P24 without saving.
Note: Through the setup menu is possible to set only one NTP server IP address.
If more than one NTP server addresses were previously configured (using telnet
or MOBA-NMS tool), after opening the
P24 submenu the IP address of currently
active NTP server is displayed. When the IP address was modified and the
configuration is saved using the setup menu, the IP address is stored to the
definition of the first NTP server, the other NTP server addresses are cleared
including those defined by the NTP server domain names.
4.2.9 Submenu for displaying IPv6 addresses
Choose the menu item P25 and then enter the submenu by pushing the SET for
display IPv6 address. In the submenu, select the desired IP address to display
and push the
SET button to display the first part of the IPv6 address.