© MOBATIME
15 / 32
801151.06
•
command
conf -n
displays current network parameters
•
command
conf -?
displays help for command conf parameters
•
example:
conf -i
192.168.0.190 sets the clock’s IP address to 192.168.0.190
•
it is necessary to end telnet connection by command
exit
Windows 7 note: The telnet is not activated in Windows 7 by default. For activating it go
to the “Control Panel” in “Start menu”, click on
“
rams and Features
”, click on “Turn
Windows features on or off” and find the “Telnet Client” check box
in the window
“Windows Features”
. Allow the system to install the appropriate files
–
this should take
only a few seconds. The administrator rights are necessary for this operation.
Hyperterminal note: The Hyperterminal application can be used as an alternative to
telnet. It is necessary to activate the “Send line ends with line feeds” and “Echo typed
characters locally” in the Properties
-> Settings -> ASCII setup window.
4.1.4 Setting network parameters over DHCPv6
IP clock mode must be set to IPv6 mode (P7: 0/2). Menu item
P14
must be set to
3
(default setting) or
2
. The network parameters are automatically retrieved from the
DHCPv6 server.
The following DHCPv6 options can be processed:
[3] non-temporary addresses
[16] vendor class
[17] vendor options
[23] DNS servers
[24] DNS domain
[25] Identity Association for Prefix Delegation
[31] SNTP servers
The network administrator must set the DHCPv6 options on the server accordingly.
Assigned parameters can be checked in the
P14
submenu.
4.1.5 Setting network parameters over autoconfiguration (SLAAC)
IP clock mode must be set to IPv6 mode (P7: 0/2). Menu item
P14
must be set to
3
(default setting) or
1
.
The following SLAAC options can be processed:
[3] Prefix info
[5] MTU
[24] Route info
[25] RDNSS
The network administrator must set the SLAAC options on the server accordingly.
Assigned parameters can be checked in the
P14
submenu
4.1.6 SNMP
The ECO-DC clock supports SNMP version 2c notifications and parameter reading and
setting by means of SNMP GET and SET commands. This allows to integrate the clock
to a network management system. The ECO-DC (SNMP agent) can send alarm
notifications and alive notifications to a SNMP manager. The IP address of the SNMP
manager can be provided to the clock by DHCP, Telnet, SNMP or the MOBA-NMS.
The structure of supported parameters is defined in a MIB file (refer to document TE-
800728 or BE-800793 for details). In addition the clock supports
the “system” node
parameters defined by MIB-2 (RFC-1213)
Alarm notifications are asynchronous messages and are used to inform the manager
about the appearance / disappearance of alarms.
Alive notifications are sent out periodically to report availability and state of the clock.
The interval time can be configured.
