Installation
1
Define the position of the joystick.
When the arrow at the bottom of the joystick points to the front, a
forward movement of the joystick will result in an according forward
movement of the wheelchair.
If needed, you can change this positioning in steps of 90° with the
Configurator Software.
2
Place the mounting ring around the joystick housing.
3
Secure the Q2M half clamp to the mounting ring.
Use an Allen wrench to mount the 20 mm bolt.
NOTE:
It is not advised, but you may mount the joystick without
using the Q2M half clamp.
CAUTION:
Tighten the screws firmly, but not excessively. Excessive
force may damage the unit.
4
Slide the unit over a Q2M Rod, or any other 6 mm rod, to position the
Micro Joystick on the wheelchair.
A Q2M Rod D6 50 mm is included in your package, but you can use any
other Q2M Rod (e.g. a C- or S-Rod from the Multi Swing).
5
Place and secure the interface unit and all cabling on the wheelchair.
13
Micro Joystick Installation manual 13
