BTxxACT
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following products:
BT9ACT / BT14ACT / BT20ACT
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
•
Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
•
Remove the diffuser by rotating bezel anti-clockwise (see Fig. 1)
Fig. 1
Fig. 2
•
Remove the fastening screw securing the LED plate and open the LED plate (see Fig. 2)
•
Mark the location of the fixing holes, and drill the holes ensuring not to infringe with any gas/water
pipes or electrical cables
•
Feed the cable via the rubber grommet to retain IP rating, and secure the baseplate to the surface
•
Connect the Live (brown) and Neutral (blue) to the terminals on the terminal block (see Fig. 3)
Fig. 3
•
Refasten the LED plate screw
•
Choose the required colour temperature by means of the DIP switch (see Fig. 4)
BTxxACT
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following products:
BT9ACT / BT14ACT / BT20ACT
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
•
Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
•
Remove the diffuser by rotating bezel anti-clockwise (see Fig. 1)
Fig. 1
Fig. 2
•
Remove the fastening screw securing the LED plate and open the LED plate (see Fig. 2)
•
Mark the location of the fixing holes, and drill the holes ensuring not to infringe with any gas/water
pipes or electrical cables
•
Feed the cable via the rubber grommet to retain IP rating, and secure the baseplate to the surface
•
Connect the Live (brown) and Neutral (blue) to the terminals on the terminal block (see Fig. 3)
Fig. 3
•
Refasten the LED plate screw
•
Choose the required colour temperature by means of the DIP switch (see Fig. 4)