• Insert a GU10 LED lamp into the lamp holder. Align the pins and turn 45° clockwise to secure the lamp
(a suction cup is provided to aid insertion/removal of lamp where required)
• Replace the bezel on the fitting, insert the four screws and tighten ensuring the gasket is in place and a
tight seal is maintained
• Switch on and check for correct operation
• If the protective glass gets cracked or damaged it should be replaced immediately
• This fitting must not be used without the protective glass installed
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do
not use aggressive cleaning products or solvents which may damage the product
Do not use any source of high pressure washers to maintain or clean this product
This product is not suitable for installation in or near a coastal or marine environment
This product is dimmable dependent on lamp type
This product should be recycled in the correct manner when it reaches the end of its life. Check local
authorities for where facilities exist
GENERAL
This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance
with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch
codes will invalidate the warranty. If this product should fail within its warranty period, it should be returned
to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for
any installation costs associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.
WARRANTY
