GENERAL
WARNING
The light source of this luminaire is not replaceable; when the light source reaches its end of
life the whole luminaire should be replaced.
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm
water only, do not use aggressive cleaning products or solvents which may damage the
product.
Do not use any source of high-pressure washers to maintain or clean this luminaire.
This product is non-dimmable.
This product should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist
This product must be disconnected from the circuit if subjected to any high voltage or
insulation resistance testing. Irreparable damage will occur if this instruction is not followed.
Override Function (FLNPIR only)
• Switch the mains supply to the fitting OFF-ON-OFF-ON within three seconds. The light
flashes ON-OFF-ON to indicate that it is in override mode. To return to automatic mode,
switch the mains supply to the fitting off for at least 10 seconds, then switch on again
• The FLNMIC has no override function
Setting
FLNMIC
FLNPIR
SENS
Minimum: up to 4m / Maximum: up to 12m
Minimum: up to 5m / Maximum: up to 10m
LUX
Minimum: 3 lux / Maximum: 2000 lux
Minimum: 10 lux / Maximum: 2000 lux
TIME
Minimum: 10 sec / Maximum: 15 min
Minimum: 10 sec / Maximum: 7 min
