29
When loosing the Cutting Head Adjusting Knob, the Cutting Head will pivot
down unless held.
(A)
Ensure the ON/OFF Switch
is in the OFF position.
(B)
Plug saw into the GFCI.
(C)
Plug the GFCI into the
power source.
(A)
Loosen Cutting Head
Adjusting Knob.
(B)
Set cutting depth approximately
1/4 to 1/2 inch below the
surface of the Movable
Cutting Table.
(C)
Tighten the Adjusting Knob.
CAUTION
Set Cutting Depth
MK-101-24HD
SETUP
VOLTAGE:
120V
CYCLE:
60hz
PHASE:
1-phase
PORTABLE GENERATOR
ELECTRIC RECEPTACLE
4. I f using an extension power cord, make sure, the length and wire gauge cor-
respond to the requirements listed in on page 12. An extension power cord
that is too small in wire gauge (diameter), or too long in length, will cause the
motor to overheat and could cause premature failure.
5. Use an approved Ground Fault Circuit Interrupter (GFCI)
6. Do not cover the motor vents as this could lead to motor overheating.
In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
A GFCI wall socket is the preferred protective device.
NOTE:
NOTE:
5 KW 120/240 volts 41.7/20.8 amps Single Phase
If using a portable generator, ensure the generator meets the following minimum requirements:
Summary of Contents for MK-101-24HD
Page 19: ...19 NOTES ...
