8 INSPECTION AND MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
174
Pub. No. K29001-00320 Revision: 1
Intake and Exhaust Systems -
Check
• Devices and equipment outside the
scope of our supply are included in the
facility. For the details, refer to such a
document as the specification sheet
prepared by the generator supplier.
• For the devices and equipment outside
the scope of our supply, refer the
corresponding manual of the generator
and the supplier's operation manual.
Turbocharger - Check
• For the location of the turbocharger,
refer to
.
• When the inspection requires the
removal of turbocharger, contact your
SME dealer
1
Remove the pipe on the inlet side.
2
Rotate the tightening nut of the
compressor wheel by hand to check
that it rotates smoothly.
Fig. 8-108 Turbocharger - Check
• If a play or sluggish rotation is
detected, contact your SME dealer
3
Check the compressor wheel fins for
discoloration or damage.
• If discoloration or damage is
detected, contact your SME dealer
Exhaust Muffler - Drain Water
Be sure to drain the exhaust muffler.
• The exhaust muffler is outside the
scope of our supply.
For the details, refer to the
corresponding manual of the generator
and the supplier's operation manual.
Before checking the turbocharger,
make sure that the engine has cooled
down to normal temperature. Before
checking, make sure that the
compressor wheel is not rotating.
* Otherwise, you could get burned.
* If you are caught in a rotating compressor
wheel, you will suffer laceration.
Make sure that there is no intake air
leak in the piping to the compressor of
the turbocharger.
* If there is intake air leak, insufficient boost
pressure could occur, which could cause
deterioration in the exhaust gas properties.
Check that the compressor or turbine
of the turbocharger is not dirty.
* If the compressor or turbine of the turbocharger
is dirty, performance degradation of the
turbocharger may occur, which could cause
power reduction.
Do not touch the exhaust muffler
immediately after the engine is
stopped.
• Make sure that the engine is cooled down
to the normal temperature.
* Otherwise, you could get burned.
Summary of Contents for S16R
Page 215: ......