3 - 11
MELSEC-Q
3 SPECIFICATIONS
(2) Output signals
Device No.
Signal name
Description
Y9
Operating
condition setting
request
(1) This turns ON when A/D conversion is enabled/disabled, or when averaging
processing specification, the settings for the average time or number of times (when
averaging processing is specified) is enabled.
(2) See the X9 column for ON/OFF timing.
YA
User range write
request
(1) This turns ON when the value for the adjusted offset/gain settings are registered in
the A/D conversion module.
(2) See the XA column for ON/OFF timing.
See Section 4.6 for offset/gain settings.
YB
Channel change
request
(1) This turns ON when changing the channel for which offset/gain settings are to be
performed.
(2) See the XB column for ON/OFF timing.
See Section 4.6 for offset/gain settings.
YD
Maximum value/
minimum value
reset request
(1) The maximum and minimum values stored in buffer memory addresses 30 to 45
(Un\G30 to Un\G45) are cleared by setting the maximum and minimum value reset
request (YD) to ON.
YF
Error clear request
(1) This turns ON when a write error is cleared.
(2) See the XF column for ON/OFF timing.
Summary of Contents for Q64AD
