App
- 19
Appendix 4 Sample Programs when Using CC-Link
Appendix 4.4 Parameter Settings
APPENDICES
6) Special Relay (SB)
Set the special relay (SB) refresh device to SB400, "Special relay (SB)".
7) Special Register (SW)
Set the special register (SB) refresh device to SW400, "Special register (SW)".
8) Retry Count
Use the retry count for communication errors to "3 (Default)".
9) Automatic Reconnection Station Number
Use 1 link scan for return to system, set at "1(Default)".
10) Standby Master Station No.
Set the standby master station number to station number "5".
11) PLC Down Select
Use the data link status as "Stop (Default)" for when CPU errors occur in the
master station sequence.
12) Scan Mode Setting
Use the setting for link scan for sequence scan as "Asynchronous (Default)".
13) Delay Information Setting
Use the link scan interval as "0(Default)".
14) Station Information Setting
Set the station information to "Station Information Settings" as shown in
Diagram App.5.
Diagram App.5 CC-Link Station Information Setting
