Mitsubishi PAC-SF44SRA, Instruction Book

Page: 23 / 206

6-1-2. Setting the interlocked units
• Set that units interlocked with each group can be run in linked.
• Set the interlocked units after setting the group.
The interlocked units cannot be set until the units are registered in the group in which interlocked
units are to be set.
• When registering the interlocked unit, if an indoor unit and interlocked unit in a certain
group are to be linked, always register the indoor unit with the smallest address No.
in the group for interlocking. If the unit is not registered for interlocking, the
interlocked unit cannot be operated (ventilation changeover) with the local remote
controller.
• If there are several indoor units to be linked with the interlocked unit, register all
indoor units for interlocking.
1. Calling the Interlocked Unit Setting Screen
(1) Open the Interlocked Unit Setting Screen from the Group Setting Screen.
Press the COL./GROUP switch.
23
GB
1. Calling the Interlocked Unit Setting Screen
2. Selecting the group No.
Select the group in which the interlocked units are to be registered.
This same step is used for searching and deleting.
3. Calling the registration uni
t
4. Selecting the interlocked unit's address No.
5. Registering the interlocked uni
t
6. Cancelling the interlock setting
7. Searching for interlocked units
Go to step 6-1. (4) or 6-1-1.
The screens will alternate between
the Group Setting Screen and Interlocked Unit
Setting Screen each time the COL./GROUP switch
is pressed.
"--" or attributes are displayed after two seconds.
"---" or unit address is displayed.
"--" or attributes are displayed after two seconds.
"---" or unit address is displayed.
Interlocked unit address No. display section